5A05 Aluminum Bars Specifications
Standards: ASTM B221, B211, B565, B316 3003, DIN AlMnCu
Aluminum bar form: Aluminum round, hexagonal, flat, semi-circular, oval, rectangular black, and glossy finish
Aluminum round bar diameter: 0.1-600mm, etc.
Aluminum hexagonal bar: 0.1-600mm, etc.
Aluminum angle bar size: 0.5mm*40mm*40mm-20mm*400mm*400mm
Aluminum flat steel thickness: 0.1-600mm, etc.
Aluminum flat bar size: 1-2500mm, etc.
Aluminum round bar length: 1-12m, random, fixed, and cut length or according to customer requirements
Product Introduction
Magnesium content is high, its strength is low, plasticity is high, corrosion resistance is good
5A05 is Al-Mg anti-rust type aluminum alloy, which cannot be strengthened by heat treatment. The alloy has a higher magnesium content and lower strength, which is similar to alloy 5A03. Cold deformation of the alloy can increase strength, but the plasticity is reduced. The plasticity of the annealing state is high, and the plasticity of the semi-cold work hardening state is acceptable. The corrosion resistance of the alloy is good and the weldability is acceptable, suitable for spot welding, atomic hydrogen welding, gas welding, argon arc welding. Its machinability, annealing state is very poor, semi-cold work hardening state is still good.
5A05 alloy is commonly used to manufacture welded pipes, welded fuel tanks and other liquid containers, and other parts that require high process plasticity, good corrosion resistance, and moderate loads; Wire is used as welding rods and rivets, which require an anodizing. In foreign countries, similar alloys (such as 5456) are used to make armor plates and high-strength structural parts. Storage tanks, pressure vessels, and marine parts.
Typical uses
5A05 is widely used in the production of armor plates, high-strength structural parts. Storage tanks, pressure vessels, and marine parts.
Chemical composition
Alloy grade | Si | Fe | Cu | Mn | Mg | Cr | Zn | Ti | Zr | other | AL | ||
new grade | old grade | 0.50 | 0.50 | 0.10 | 0.3-0.6 | 4.8-5.5 | —— | 0.20 | —— | —— | each | total | |
5A05 | LF5 | 0.05 | 0.15 | Allowance |
Mechanical properties
Aluminum alloy grade and state | Tensile strength Rm/Mpa | Yield strength Rp0.2/Mpa | Elongation/% | Hardness/ HBWα |
5A05-H112 | 265 | 118 | 15 | —— |
Quality characteristics
Density:2.8g/cm³。
5A05 Aluminum Bar Packages
The following is our company’s standard aluminum coil export packaging. If the customer has any packaging requirements, our company can meet them.